What is the most effective method to remove the old hard adhesive? - Billy T.ĭear Billy: Preparing the wall for the new tiles is always the most difficult part of the project especially when the old tiles have been up for many years. This 511 Impregnator Sealer is meant to actually penetrate into the surface to create an invisible layer – not just sit on the surface… which is why it’s best used for porous surfaces.Dear James: One room has old plastic tiles and I want to remove and replace them with more modern tile. The steps are easy: wipe on the surface, let sit for 3-5 minutes, then wipe off the excess.Ĭement tiles are more porous than most surfaces so I chose to do 2 coats! I waited overnight between my coats but I don’t think that’s necessary. It comes with a tray for a really easy application. There were some areas that had water spots that I did end up using 400 grit sandpaper to remove… even that didn’t remove them completely but they are 95% gone which is more than I had hoped for.Īfter the tile was completely dry, it was time to seal! This 511 Impregnator Sealer is the real deal… it’s meant for medium to dense porous surfaces including sanded grout and most tiles – both interior and exterior. This step is important! I was pretty dang happy with the results. I was shocked at how clean the tiles and grout got after using this cleaner… and even more surprised that I didn’t realize how dirty they were! It even removed some nail polish that I’ve tried for 2 years to remove!Īfter scrubbing the floor in sections, I used a damp rag to get all the residue off. ![]() I could see using this just to clean your grout if it’s gotten dingy over the years. I’m happy to add this to my cleaning arsenal!Īs I was saying… this stuff is powerful. I am using it to clean my cement tiles and grout – but it can be used to remove mortar residue, grout, hard water deposits, and rust from just about any material. One thing to note about this cleaner is that it is recommended at different dilution ratios depending on the job at hand. At this point, you could scrub normally with a rag or pad, but I used my favorite drill scrubber trick. I put the cleaner in a spray bottle at full strength and sprayed it all over the floor – letting it sit for more than 5 minutes. I have a video below with neither but I added one after I shot the short video. You should wear gloves and a mask if you will be touching it. ![]() Note, this is strong stuff and should be used cautiously. I decided to try the cleaner first and then I could move on to sanding if I felt I needed it.įor this step, I used this Acid Substitute. After a little more research I read that I could sand with fine-grit sandpaper or use a heavy-duty cleaner. I felt like the tile was permanently stained. This was a fairly straight forward process – but I was worried about getting the tile clean enough to my liking before applying sealer. I needed to start over and re-seal it the proper way. I probably didn’t seal it well enough when I installed it… and 2. ![]() After hours of research, I was led to the conclusion that 1. No matter how hard I’ve tried to keep it clean, it never looks clean. ![]() I installed this beautiful real cement tile in my home 3 years ago and let’s just say that it’s seen better days. If you’re a homeowner, you probably have tile somewhere in your home. This post is in partnership with Rust-Oleum.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |